Connecting The Water Supply Hose; Note For Connection; Checking The Rubber Seal; Connecting The Hose To The Water Tap - LG F6V910WTSA Owner's Manual

global_main.book.book Page 21 Monday, May 10, 2021 9:22 AM

Connecting the Water Supply Hose

Note for Connection

• Water pressure must be between 50
kPa and 800 kPa (0.5‒8.0 kgf/cm²). If
the water pressure is more than 800
kPa, a decompression device should
be installed.
• Periodically check the condition of the
water supply hose and replace the
water supply hose if necessary.
NOTE
• Do not overtighten the water supply
hose or use mechanical devices to
tighten onto the inlet valves.
• No further backflow protection
required for connection to the water
inlet.

Checking the Rubber Seal

Two rubber seals are supplied with
A
the water supply hose. They are used to
prevent water leaks. Connection to taps
is sufficiently tight.
• Do not use mechanical devices such as
multi grips to tighten the water supply
hose. Ensure that the curved end of
the water supply hose is connected to
the appliance.
INSTALLATION
Connecting the Hose to the
Water Tap
Connecting Screw-Type Hose to Tap
with Thread
Screw the supply hose connector onto
the water supply tap. Hand tighten only
with the aid of a soft cloth. Do not
overtighten the supply hose with any
mechanical device.
NOTE
• After connecting the water inlet hose
to the water tap, turn on the water tap
to flush out foreign substances (dirt,
sand, sawdust, and etc.) in the water
lines. Let the water drain into a bucket,
and check the water temperature.
21