Brilliance Sharing With Ec-3000 Units - Furuno VR-7000S Installation Manual

3. SETTING UP THE EQUIPMENT
5. Put a check in check box for [Fixed DRU Connection] (VR-7020) or [Float DRU
Connection] (VR-7021F) as appropriate for your system configuration.
[Fixed DRU Connection] is checked by default.
6. Confirm that [SAVE Function] is checked.
This field is not checked if VR-7000 is selected step 4.
7. Click the [Set] button.
8. From the menu, select [Maintenance], [VDR Config Management], [Upload].
9. A confirmation window appears; click the [OK] button to start uploading to the
VDR.
10. Click the [Write] button.
11. The message "VDR will be rebooted. Continue?" appears. Click the [OK] buttonto
continue.
You are logged out of the VDR Maintenance Viewer. The reboot takes several
minutes.
12. After the reboot, press the MENU/ESC key to open the main menu on the base
screen of the RAP (Remote Alarm Panel).
13. Use the cursorpad (
[Enter Password] pop-up window appears.
14. Press
15. Use the cursorpad (
16. Use the cursorpad (
Note 1: Using the VR-7000S, make the [SAVE Function] active.
Note 2: About the [SAVE Function], if each setting between DCU and RAP is dif-
ferent, the alert appears. Using the VR-7000, make the [SAVE Function] inactive.
Using the VR-7000S, make the [SAVE Function] active.
Note 3: If you select the different recording unit step 5 from the recording unit ac-
tually installed, the alert appears. Select the correct recording unit step 5.
3.5

Brilliance Sharing with EC-3000 Units

The RAP can share the brilliance settings with EC-3000 units (ex: ECDIS, chart radar)
in the same network. When you adjust the brilliance of the EC-3000 units, the bril-
liance of the RAP is automatically changed. Note that the brilliance of the EC-3000
units is not changed when the RAP brilliance is changed.
To enable the brilliance sharing function, do as follows.
Note: The VDR software version must be "01.40" or later to use the brilliance sharing
function.
1. Start the VDR Maintenance Viewer.
2. From the menu, select [Maintenance], [VDR Config Management], [Download].
Click the [OK] button twice then the [Close] button.
3. Click the [System] tab.
4. Put a check in check box for [Brilliance Sync Function].
5. Click the [Set] button.
6. From the menu, select [Maintenance], [VDR Config Management], [Upload].
3-4
or ) to select [Settings], [Servicemen Settings] in order.
, , , , MENU/ESC, ENT in order.
or ) to select [Save Function] then press the ENT key.
or ) to select [ON] then press the ENT key.