Trunnion Disassembly; Greenlee Textron - Greenlee 855 Instruction Manual

Trunnion Disassembly

1. Support entire weight of bender (approx. 500 lbs.)
at lifting eyes, but do not lift above floor.
Note: Lifting slings must attach to lifting mechanism
within the width boundaries of the bender to prevent
the lifting eyes from sliding off once the retaining
rings are removed.
CORRECT
Greenlee Textron / Subsidiary of Textron Inc.
855 Smart Bender™
INCORRECT
2. Remove support tower on the rotary selector switch
side.
a. Remove four bolts, two nuts and crossbar at
base of tower.
b. Remove outer retaining ring on each side of the
bender.
c. Slide tower off of pivot spindle.
3. Slide the remainder of the trunnion assembly off the
opposite pivot spindle.
Bender head may rotate a bit when locking detent
pin is disengaged. Keep hands clear.
4. Remove remaining support tower from base.
5. Pull out detent pin, knob and spring.
6. Remove four bolts and swivel casters on each side.
7. Remove stationary wheels.
a. Remove retaining rings on axle.
b. Press out axle.
c. Remove wheel and washers from each side.
8. Remove kickstand.
a. Loosen set screw in collar.
b. Press out pin.
c. Remove kickstand weldment.
9. Assemble in reverse order, except for leaving out
the detent pin, knob and spring. After all else is
assembled, rotate the bender head so the top of the
bender is pointed toward the kickstand, and insert
the detent pin assembly. Hold the detent pin in while
rotating the bender head back to one of its normal
positions.
38 4455 Boeing Dr., Rockford, IL 61109-2988 815/397-7070