Table of Contents
Advertisement
Operation — Optional Deluxe Pendant
Enter all dimensions in inches, converting any fractions
to decimals using the Decimal Conversion Chart below.
1. Upon power-up, the SELECT CONDUIT SIZE
prompt will be displayed alone.
2. The sequence of prompts or displays is:
a. SELECT CONDUIT SIZE
b. SELECT CONDUIT TYPE
c. SELECT TYPE OF BEND
d. SELECT ANGLE
e. SELECT HEIGHT
f.
SELECT LENGTH (This prompt is skipped
when the bend type is a stub.)
g. MARK 1= .... PRESS ENTER TO GO ON
h. SET FRONT OF HOOK AT MARK 1...
i.
SET HOME POSITION (This prompt is dis-
played when BEND is pressed and until the
home switch has been tripped for the size and
type of conduit selected. The bend angle will be
displayed once the home switch is tripped. The
display will show SET HOME POSITION each
time BEND is pressed after there is a change to
conduit type, conduit size change to the other
shoe, after pressing RESET, and when power
to the bender has been interrupted. SET HOME
POSITION prompt will be skipped if the home
switch was previously tripped.)
Greenlee Textron / Subsidiary of Textron Inc.
855 Smart Bender™
Decimal
Conversion
1/16
.06
1/8
.12
3/16
.18
1/4
.25
5/16
.31
3/8
.37
7/16
.43
1/2
.50
9/16
.56
5/8
.62
11/16
.68
3/4
.75
13/16
.81
7/8
.87
15/16
.93
j.
00o to 99o (Bend angle is displayed when
BEND is pressed and after the home switch has
been tripped.)
k. SET FRONT OF HOOK AT MARK 2 ...
(This display is skipped for stubs.)
l.
00o to 99o
m. SET FRONT OF HOOK AT MARK 3 ...
(This display is skipped for stubs and offsets.)
n. 00o to 99o
p. MARK 1 = ... PRESS ENTER TO GO ON
(The display will repeat the bend layout for
duplicate bends.)
3. Pressing any of the six conduit size keys at any
point will set that size into memory and display the
SELECT CONDUIT TYPE screen.
4. Pressing the conduit type key at any point will cycle
through the conduit types in the order of EMT, IMC,
RIG, ALM, PVC ... etc. The pendant will then
display SELECT TYPE OF BEND.
5. Pressing any of the three bend-type keys (STUB,
OFFSET or SADDLE) at any time will set that bend
type in memory and display the SELECT ANGLE
screen.
6. Pressing the ANGLE key at any point will display
the SELECT ANGLE screen and allow changing of
the angle with the numerical keys, then press
ENTER. The ANGLE key does not need to be
pressed if SELECT ANGLE is already displayed.
7. Pressing the HEIGHT key at any point will display
the SELECT HEIGHT screen and allow changing
of the height with the numerical keys and pressing
ENTER. The HEIGHT key does not need to be
pressed if SELECT HEIGHT is already displayed.
8. Pressing the LENGTH key at any point will display
the SELECT LENGTH screen and allow changing of
the length with the numerical keys and pressing
ENTER, unless the bend type is a stub in which
case the LENGTH key will do nothing. The LENGTH
key does not need to be pressed if SELECT
LENGTH is already displayed.
11
4455 Boeing Dr., Rockford, IL 61109-2988 815/397-7070
Hide quick links:
Advertisement
Table of Contents
