Specifications - H6200B Chain Saw; Saw Chain; Hydraulic Power Source - Greenlee 42247 Operation, Service And Parts Instruction Manual

Specifications – H6200B Chain Saw
Length ................................................................................................................... 28.0 in (71.1 cm)
Width .......................................................................................................................... 8 in (20.3 cm)
Height ......................................................................................................................... 9 in (22.9 cm)
Guide Bar - Actual Length ....................................................................................... 19 in (48.3 cm)
- Cutting Capacity ................................................................................... 15 in (38.1 cm)
Weight - with Guide Bar and Chain ........................................................................ 10.4 lbs (4.7 kg)
Chain Speed - Feet Per Minute @ 4 gpm (15.1 l/m) .................................... 1814 fpm (553 m/min)
Type of Hydraulic System ............................................................... Open-Center or Closed-Center
Pressure Port - Tool .............................................................................................. 9/16 SAE Thread
Return Port (Tank) - Tool ........................................................................................ 3/4 SAE Thread
Specifications — Saw Chain
• Always use saw chains that meet applicable industrial safety code specifications.
• Always use saw chains rated for 3600 fpm or higher.
Failure to observe these warnings could result in severe injury or death.
A saw chain is furnished with the tool. Replacement saw chains are available from Greenlee Fairmont as repair parts.
CONTACT AUTHORIZED GREENLEE FAIRMONT DISTRIBUTOR. Any saw chain used with this chain saw must meet
the following requirements:
Pitch ........................................................................................................................ 3/8 in (9.5 mm)
Gauge ................................................................................................................... .050 in (1.3 mm)
Rated Feet Per Minute - Minimum ............................................................. 3600 fpm (1097 m/min)
Specifications — Hydraulic Power Source
• Power source flow must not exceed 8 gpm.
• Limit relief pressure to 2000 psi.
Failure to observe these warnings could result in excessive chain speed and over-pressurizing the system,
which could result in severe injury or death.
Any hydraulic power source used with this tool must meet the following requirements:
Type of Hydraulic System ............................................................... Open-Center or Closed-Center
Flow - Minimum .................................................................................................... 4 gpm (15.1 l/m)
- Recommended .......................................................................................... 6 gpm (22.7 l/m)
- Maximum ................................................................................................... 8 gpm (30.2 l/m)
Operating Pressure - Minimum ........................................................................ 1000 psi (69.0 bar)
Pressure Relief Setting ................................................................................... 2000 psi (137.9 bar)
Filtration ........................................................................................................... 10 Micron (Nominal)
Back Pressure - * Maximum ................................................................................ 200 psi (13.8 bar)
Greenlee Textron / Subsidiary of Textron Inc.
H6200B / 42247 Chain Saw
@ 6 gpm (22.7 l/m) .................................... 2671 fpm (814 m/min)
@ 8 gpm (30.2 l/m) .................................. 3527 fpm (1074 m/min)
- Maximum ..................................................................... 2000 psi (137.9 bar)
7
4455 Boeing Dr., Rockford, IL 61109-2988 815/397-7070