Assembly - Greenlee 42247 Operation, Service And Parts Instruction Manual

Assembly (cont'd)
Auxiliary Handle and Knuckle Guard
1. Install the auxiliary handle (28) and close-out (31) to
the saw head body (1) using one 1/4 inch oval head
machine screw (32), one 1/4 inch hex socket head
cap screw (29) and 1/4 inch hex elastic stop nut
(30).
2. Install the knuckle guard (47) to the sprocket cover
(48) using one 1/4 inch button socket head cap
screw (65), two external tooth lock washers (66),
one each side of knuckle guard, and one 1/4 inch
hex elastic stop nut (64).
Drive Sprocket and Spacer
Install the Woodruff key (33) in the drive shaft (5). Install
the drive sprocket (52), washer (51) and washer (50) on
the drive shaft. Secure with the 1/2 inch hex elastic stop
nut (49). Hold the sprocket (52) and tighten the stop nut
securely.
Saw Chain, Guide bar and Sprocket Guard
1. Install the 1/4 inch adjusting screw (55) and dog
(56) in the bar holder (54), if removed.
2. Position the guide bar (57) on the saw head body
(1). Install the bar holder (54) to the saw bar align-
ing the dog (56) in the bar holder with the hole
below the long adjusting slot in the guide bar (57)
and secure with two 5/16 inch hex head cap screws.
3. Install the saw chain (58) on the drive sprocket and
around the guide bar (57) groove.
4. Install the sprocket cover (48) and spike rack (63) to
the saw head with one 5/16 socket head cap screw
and the 5/16 hex head grip nut. Make sure spacer
(61) is in place.
5. Secure the other end of the spike rack to the saw
head with one 5/16 hex head cap screw (62).
6. Secure the sprocket cover with four 1/4 x 3/4 inch
hex socket head cap screws (45).
7. Adjust the saw chain tension before using the chain
saw. See Saw Chain Tension (page 15).
Greenlee Textron / Subsidiary of Textron Inc.
H6200B / 42247 Chain Saw
27
4455 Boeing Dr., Rockford, IL 61109-2988 815/397-7070