Specifications - 49200 Chain Saw; Saw Chain; Hydraulic Power Source - Greenlee 49200 Operation, Service And Parts Instruction Manual

Specifications – 49200 Chain Saw
Length ................................................................................................................ 40.0 in (101.6 cm)
Width ......................................................................................................................... 8 in (20.3 cm)
Height ........................................................................................................................ 9 in (22.9 cm)
Guide Bar - Actual Length ...................................................................................... 30 in (76.2 cm)
- Cutting Capacity ................................................................................. 27 in (68.6 cm)
Weight - with Guide Bar and Chain .......................................................................... 12 lbs (5.4 kg)
Chain Speed - Feet Per Minute@ 8 gpm (30.2 l/m) .................................... 2351 fpm (717 m/min)
Type of Hydraulic System .............................................................. Super Spool™ Selector Control
Pressure Port - Tool ................................................................................. 1/2" HTMA Coupler Body
Return Port (Tank) - Tool ............................................................... 1/2" HTMA Coupler Nose Piece
Specifications — Saw Chain
• Always use saw chains that meet applicable industrial safety code specifications.
• Always use saw chains rated for 3600 fpm (1097 m/min) or higher.
Failure to observe these warnings could result in severe injury or death.
A saw chain is furnished with the tool. Replacement saw chains are available from Greenlee Fairmont as repair
parts. CONTACT AUTHORIZED GREENLEE FAIRMONT DISTRIBUTOR. Any saw chain used with this chain saw
must meet the following requirements:
Pitch .............................................................................................. 3/8 in (9.5 mm)
Gauge ......................................................................................... .050 in (1.3 mm)
Rated Feet Per Minute - Minimum ................................... 3600 fpm (1097 m/min)
Specifications — Hydraulic Power Source
• Power source flow must not exceed 8 gpm.
• Limit relief pressure to 2000 psi.
Failure to observe these warnings could result in excessive chain speed and over-pressurizing the system,
which could result in severe injury or death.
Greenlee Textron / Subsidiary of Textron Inc.
49200 Chain Saw
@ 9 gpm (34.1 l/m) .................................... 2645 fpm (806 m/min)
@ 10 gpm (37.9 l/m) .................................. 2939 fpm (896 m/min)
for use on Open-Center or Closed-Center
7
4455 Boeing Dr., Rockford, IL 61109-2988 815/397-7070