Hoses And Fittings; Tool/Hose Connections - Greenlee 42247 Operation, Service And Parts Instruction Manual

Hoses and Fittings

Hoses and fittings used with this tool must comply
with S.A.E. Standard J1273 (See Appendix A)
recommended practice for selection, installation
and maintenance of hose and hose assemblies.
Failure to observe this standard could result in
severe injury or death.
Hose assemblies and quick connect couplers are
available from Greenlee Fairmont as accessories. SEE
BULLETIN 999 1032.2 ON GREENLEE FAIRMONT
COUPLERS AND HOSES. CONTACT AUTHORIZED
GREENLEE FAIRMONT DISTRIBUTOR.
Greenlee Textron / Subsidiary of Textron Inc.
H6200B / 42247 Chain Saw

Tool/Hose Connections

Always stop power source before connecting or
disconnecting tool.
Failure to observe this warning could result in
severe injury or death.
Connecting Hoses (See Figures 1, 2, and 3)
1. STOP THE POWER SOURCE.
2. Connect the return (tank) hose from the power
source (port T) to the tool (T port).
Note: Return (tank) hose connection should always
be connected before supply (pressure) hose
connection to prevent pressure build-up inside
the tool.
3. Connect supply (pressure) line from the power
source (port P) to the tool (P port).
Disconnecting Hoses (See Figures 1, 2, and 3)
1. STOP THE POWER SOURCE.
2. Disconnect the supply (pressure) hose connection
from the power source (port P) to the tool (P port).
Note: Supply (pressure) hose connection should
always be disconnected before return (tank)
hose connection to prevent pressure build-up
inside the tool.
3. Disconnect the return (tank) hose from the power
source (port T) to the tool (T port).
4. To prevent contamination, always install dust caps
over the hydraulic ports of the chain saw when
disconnected.
9
4455 Boeing Dr., Rockford, IL 61109-2988 815/397-7070