Specifications - Chain Saw; Saw Chain; Hydraulic Power Source - Greenlee 43179 Limb-Lopper Operation, Service And Parts Instruction Manual

GREENLEE FAIRMONT

Specifications - Chain Saw

Length - with Guide Bar ................................................................................... 22 in. (55.8 cm)
Width .................................................................................................................. 7 in. (17.8 cm)
Height ......................................................................................................... 13-1/2 in. (34.3 cm)
Weight - with Guide Bar ...................................................................................... 7 lbs. (3.2 kg)
Guide Bar - Cutting Length ................................................................................. 13 in. (33 cm)
Chain speed - Feet Per Minute @ 4 gpm (15.1 l/m) .............................. 1814 fpm (552 m/min)
Type of Hydraulic System .... Super Spool
Pressure Port ......................................................................... 9/16 in - 18 Female SAE O-Ring
Return Port ............................................................................... 3/4 in - 16 Female SAE O-Ring

Saw Chain

• Always use saw chains that meet applicable industrial safety code specifications.
• Always use saw chains rated for 3600 fpm or higher.
Failure to observe these warnings could result in severe injury or death.
A saw chain is furnished with the tool. Replacement saw chains are available from Greenlee
Fairmont as repair parts. CONTACT AUTHORIZED DISTRIBUTOR. Any saw chain used with
this chain saw must meet the following requirements:
Pitch ................................................................................................................................. .325"
Gauge .............................................................................................................................. .058"
Rated Feet Per Minute - Minimum .............................................................................. 3600 fpm
Specifications — Hydraulic Power Source
• Power source flow must not exceed 8 gpm.
• Limit relief pressure to 2000 psi.
Failure to observe these warnings could result in excessive chain speed and over-pressurizing the system,
which could result in severe injury or death.
Any hydraulic power source used with this tool must meet the following requirements:
Type of Hydraulic System ......................................................... Open-Center or Closed Center
Flow - Minimum .............................................................................................. 5 gpm (15.1 l/m)
- Recommended .................................................................................... 6 gpm (22.7 l/m)
- Maximum ............................................................................................. 8 gpm (30.2 l/m)
Operating Pressure - Minimum .................................................................. 1000 psi (69.0 bar)
Pressure Relief Setting ............................................................................. 2000 psi (137.9 bar)
Filtration ..................................................................................................... 10 Micron (Nominal)
Back Pressure - *Maximum ........................................................................... 200 psi (13.8 bar)
Greenlee Fairmont Textron / Subsidiary of Textron Inc.
Pistol Grip Chain Saw
@ 6 gpm (22.7 l/m) .............................. 2671 fpm (814 m/min)
@ 8 gpm (30.2 l/m) ............................ 3527 fpm (1075 m/min)
TM
Selector (for Open- or Closed-Center Operation)
- Maximum ............................................................... 2000 psi (137.9 bar)
7
4455 Boeing Drive, Rockford, IL 61109 815/397-7070