Recommended Hydraulic Fluids - Greenlee 42247 Operation, Service And Parts Instruction Manual

Specifications — Hydraulic Power Source (cont'd)
* 200 psi is the maximum agreed standard for the Hydraulic Tool Manufacturers Association (HTMA). Greenlee Fairmont
hydraulic tools will operate satisfactorily at this standard.
1. Maximum hydraulic fluid temperature must not exceed 140 F (60 C) at the maximum expected ambient tem-
perature. A sufficient oil cooling capacity is needed to limit the hydraulic fluid temperature.
2. Maximum hydraulic flow must not exceed 8 gpm. Install a flow meter in the return line to test the rate of hydraulic
flow in the system before working the tool.
3. The pressure relief valve must not exceed 2000 psi @ 8 gpm. The pressure relief valve must be located in the
supply circuit between the pump and tool to limit excessive hydraulic pressure to the tool.
4. Figure 3 shows a typical hydraulic power source being used with the tool.
RESERVOIR

Recommended Hydraulic Fluids

Electrical shock hazard: Use only hydraulic fluid with dielectric properties when utilizing this tool near energized
electrical lines.
Failure to observe this warning could result in severe injury or death.
Any non-detergent hydraulic fluid which meets the following specifications or HTMA specifications may be used.
S.U.S. @ 100 F (38 C) ......................................................................... 140 to 225
Flash Point ...................................................................... 340 F min (170 C min)
Pour Point ......................................................................... -30 F min (-34 C min)
Greenlee Textron / Subsidiary of Textron Inc.
Hydraulic Schematic
(10 MICRON)
RELIEF
VALVE
2000 PSI
CONTROL
VALVE
PUMP
POWER SOURCE
@ 210 F (99 C) ...................................................................... 40 minimum
H6200B / 42247 Chain Saw
Figure 3
FILTER
COOLER
T
FLOW METER
P
8
4455 Boeing Dr., Rockford, IL 61109-2988
TOOL
815/397-7070