Grandstream Networks HT-486 User Manual page 34

HandyTone-486 User Manual
Session Expiration
Min-SE
Caller Request
Timer
Callee Request
Timer
Force Timer
UAC Specify
Refresher
UAS Specify
Refresher
Force INVITE
Firmware Upgrade
and Provisioning
Firmware Server
Path
Config Server Path
Firmware File
Prefix
Firmware File
Postfix
Config File Prefix
Config File Postfix
Grandstream implemented SIP Session Timer. The session timer extension
enables SIP sessions to be periodically "refreshed" via a re-INVITE request.
Once the session interval expires, if there is no refresh via a re-INVITE
message, the session will be terminated.
Session Expiration is the time (in seconds) at which the session is considered
timed out, if no successful session refresh transaction occurs beforehand. The
default value is 180 seconds.
The minimum session expiration (in seconds). The default value is 90 seconds.
If selecting "Yes" the phone will use session timer when it makes outbound
calls if remote party supports session timer.
If selecting "Yes" the phone will use session timer when it receives inbound
calls with session timer request.
If selecting "Yes" the phone will use session timer even if the remote party
does not support this feature. Selecting "No" will allow the phone to enable
session timer only when the remote party support this feature.
To turn off Session Timer, select "No" for Caller Request Timer, Callee
Request Timer, and Force Timer.
As a Caller, select UAC to use the phone as the refresher, or UAS to use the
Callee or proxy server as the refresher.
As a Callee, select UAC to use caller or proxy server as the refresher, or UAS
to use the phone as the refresher.
Session Timer can be refreshed using INVITE method or UPDATE method.
Select "Yes" to use INVITE method to refresh the session timer.
Default method is HTTP. Firmware upgrade may take up to 10 minutes
depending on network environment. Do not interrupt the firmware upgrading
process.
IP address or domain name of firmware server.
IP address or domain name of configuration server.
Default is blank. If configured, HT486 rev. 2.0 will request the firmware file
with the prefix. This setting is useful for ITSPs. End user should keep it blank.
Default is blank. End user should keep it blank.
Default is blank. End user should keep it blank.
Default is blank. End user should keep it blank.
34
Grandstream Networks, Inc.