Related Manuals for Maktec M420
Summary of Contents for Maktec M420
- Page 1 INSTRUCTION MANUAL Jig Saw M420 009634 DOUBLE INSULATION WARNING: For your personal safety, READ and UNDERSTAND before using. SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE.
-
Page 2: Specifications
ENGLISH SPECIFICATIONS Model M420 Length of stroke 26 mm Wood 55 mm Max. cutting capacities Steel 6 mm Strokes per minute (min 0 - 3,100 Overall length 219 mm Net weight 2.6 kg Safety class • Due to our continuing programme of research and development, the specifications herein are subject to change without notice. -
Page 3: Specific Safety Rules
Do not abuse the cord. Never use the cord for 18. Do not use the power tool if the switch does carrying, pulling or unplugging the power tool. not turn it on and off. Any power tool that cannot Keep cord away from heat, oil, sharp edges or be controlled with the switch is dangerous and moving parts. -
Page 4: Functional Description
Use clamps or another practical way to secure 1. Lock button and support the workpiece to a stable platform. 2. Switch trigger Holding the work by hand or against your body 3. Speed control leaves it unstable and may lead to loss of control. screw Always use safety glasses or goggles. -
Page 5: Operation
OPERATION With the blade teeth facing forward, place the shank of the blade over the flat side of the blade holder shaft. Then place the blade clamp over the other side of the blade shank. Secure this assembly together with the bolt. Make sure that the bolt passes through the larger hole in the blade shank. -
Page 6: Metal Cutting
For internal cutouts without a lead-in cut from an 1. Hex wrench edge, pre-drill a starting hole 12 mm or more in 2. Hex bolt diameter. Insert the blade into this hole to start your cut. B) Plunge cutting 009641 Tilt the base until the desired bevel angle is obtained. -
Page 7: Dust Extraction
Dust extraction Replacing carbon brushes 1. Limit mark 009654 001145 Remove and check the carbon brushes regularly. 1. Screw Replace when they wear down to the limit mark. Keep 2. Dust nozzle the carbon brushes clean and free to slip in the holders. Both carbon brushes should be replaced at the same time. - Page 8 Makita Corporation 884874-930...