Table of Contents
Advertisement
4. Preparations for panel
Note
• Perform all the required work in "4. Preparations for panel" on
page 3 with the panel kept in the packing material (on the
bottom side).
• Do not put the panel downward or upright or leave the panel on
protruding parts.
Otherwise, scratch damage to the surface of the panel may
result.
• Do not touch the swing flap and do not put any force on the
swing flap. This will result in malfunction of the unit.
4-1
Removal of suction grille from panel,
protective corrugated cardboard, and set of
accessories
(1) Press the knobs of the suction grille and lift up the knobs.
Suction grille
Knobs
(2) Open the suction grille to an angle of approximately 45° and
remove the suction grille from the panel.
(3) Take out the protective corrugated cardboard.
Take out the protective corrugated cardboard (on top of the
panel) together with the accessories attached to the backside
of the protective corrugated cardboard.
Protective corrugated
cardboard (top)
(The accessories are
on the backside.)
Protective corrugated
cardboard (bottom)
Note
Do not impose force on the swing flap, brush unit, or air filter
when handling the panel.
Air filter
Installation manual
3
Packing material
(bottom)
Decoration panel
45°
Brush unit
Panel
Swing flap
4-2
Removal of decoration corner covers
Decoration corner cover
Decoration corner cover
Decoration corner
cover (with display)
(1) Raise and remove the decoration corner cover (with the
display) in the direction of the arrow.
Note
Do not impose force on the lead wires.
(2) Remove the screws on the backside of the decoration corner
cover (with the display), open the cover, and remove the
connector attached to the front end of the lead wires from the
PCB.
Screw
Cover
2
Connector
PCB
(3) Remove each of the remaining decoration corner covers (i.e.,
three covers) in the direction of the arrow.
Decoration corner cover
Panel
4-3
Removal of dust box
Fixing knob
Dust box
of dust box
and clasp
BYCQ140E2GW1 + BYCQ140E2GFW1 + BYCQ140E2GFW1B
Decoration
corner cover
Panel
1
Lead wires
3
Decoration corner cover
(with display)
Fixing knob of dust box
Self cleaning decoration panel
4P558847-1B 2019.02
Advertisement
Table of Contents
