Davis Instruments Vantage Pro2 Plus Manual page 13

• Exit Setup Mode by pressing and holding DONE until the Current
Weather screen displays.
Screen 1: Active Transmitters
Screen 1 displays the message "Receiving from..." and shows the transmit-
ters being received by the console. In addition, an "X" blinks in the lower
right-hand corner of the screen every time the console receives a data
packet from a station. The rest of the LCD screen is blank.
If you have a cabled station, or if your wireless ISS uses the factory set-
tings and you are receiving the signal, the screen displays "Receiving from
station No. 1". Any optional stations that have been installed should also
display.
Note: An ISS or optional station must be powered for the console to recognize it. Refer to
the Integrated Sensor Suite Installation manual or optional station installation instruc-
tions for more information.
1. Make a note of the station number(s) listed on the screen.
2. Press DONE to move to the next screen.
The console can receive signals from up to eight transmitters total, but
there is also a limit on the number of certain types of transmitters. The
table below lists the maximum number for each type of transmitter:
Integrated Sensor Suite (ISS)
Anemometer Transmitter Kit
Leaf & Soil Moisture/Temperature Station
Temperature Station
Temperature/Humidity Station
Note: Listening to more than one transmitter may reduce battery life significantly.
STATION NO.1
Screen 1: Active Transmitters
Transmitter Type
Maximum Number of Transmitters
Setup Mode
4
Maximum Number
1
1
2
8
8
10