Resolution Trident RE118 Install Manual

RE118 Interlogix
Trident
is an integrated environmental sensor. It detects water
and reports extreme temperature conditions.

Features

• Titanium probes for unmatched corrosion immunity
• IP67 rated waterproof enclosure
• GORE® vent equalizes enclosure pressure
• 5 year warranty

Enroll

by placing the panel into wireless enrollment mode and
then sending an enrollment signal from the sensor. The flood
signal is enrolled by default. To Enroll the freeze and heat
zones, remove the sensor cover. Use a wire or a paper clip
to short the desired outer terminal to the center terminal,
shorting one terminal at a time.

DL ID Configuration

• Flood zone is the serial number shown on the device
• Freeze zone is the serial number with last digit
replaced with a 1
• Heat zone is the serial number with last digit replace
with a 2.

Install

by placing the sensor in the location requiring water or air
temperature detection. If desired, the wall clip can be used to
secure the Trident sensor.

Optional Wall Clip Securing

Optional Wall Clip Securing
• Remove the Trident body from wall clip. • Remove the Trident body from wall clip.
• Secure wall clip to a wall with a #6 screw. • Secure wall clip to a surface with a #6 mounting
• Example securing locations are a wall, baseboard screw.
• Example securing locations: wall, baseboard or or cupboard.
Detects water pooled under the sensor and reports extreme air
temperature conditions.

Default Temperature Trip Points

• Heat alarms when over 100.4° F (38° C)
• Heat restores when under 96.8° F (36° C)
• Freeze alarms when under 44.6° F (7° C)
• Freeze restores when over 48.2° F (9° C)
To replace the battery, insert a flat blade screwdriver into the
front slot and twist. To reinstall the cover, align the rear latches
and roll the cover forward until it snaps into place.
Verify proper enrollment and operation using your control panel's installation manual.
® Compatible Trident ™ Environmental Sensor
I
Wall Clip
Mounting Screw Hole
Front slot