Resolution CryptiX Trident RE618 Series Install Manual

RE618 Series CryptiX
is an integrated environmental sensor. It detects lood
Trident
conditions and reports extreme temperatures. It also reports
air temperature allowing custom high and low temperature trip
points to be set in the Helix panel.

Features

• Titanium probes for unmatched corrosion immunity
• IP67 rated waterproof enclosure
• GORE ® vent to prevent seal failure
• 5 year warranty

Enroll

by placing the panel into wireless enrollment mode
and then sending an enrollment signal from the sensor.
Alternatively, the sensor can be enrolled by scanning its bar
code using the HeliLink app or by entering its 8-character
serial number on the interactive service provider's web
portal. NOTE, freeze and heat inputs must be enabled as
additional zones using the HeliLink app or the interactive
service provider's web portal.

Options for sending an Enrollment Signal

• Remove the battery tabs, OR
• Remove the wall clip from Trident body
by placing the sensor in the location requiring lood or

Install

temperature detection. If desired, the wall clip can be used to
secure the Trident sensor.

Optional Screw Mounting

• Remove the wall clip from the Trident body.
• Secure the clip to a wall, baseboard or cupboard
using a #6 screw.
• Slide the Trident body down onto the wall clip
until it snaps into place.

Detects

water pooled under the sensor and reports extreme
temperature conditions. High and low temperature trip points
are set in the Helix panel.

Default Temperature Trip Points

• Heat alarms when over 100°F (38°C)
• Heat restores when under 97°F (36°C)
• Freeze alarms when under 45°F (7°C)
• Freeze restores when over 48°F (9°C)

To replace the batteries,

the front slot and twist. Slide both old batteries out and the
new batteries in. To reinstall the cover, align the rear latches
and roll the cover forward until it snaps into place.
Use the Helix Installation Guide to verify proper system setup.
™ ™
Trident Environmental Sensor
insert a lat blade screwdriver into
Wall Clip
Mounting Screw Hole
Front slot
I