Resolution RE159 User Manual

360 Degree PIR Motion Sensor
360 PIR Motion Sensor
It is a commercial battery-powered ceiling mount sensor
with a 360 degree detection range.

Features

• 360° detection range with 62 distinct detection zones
• Range up to 40 feet in diameter
• Selectable pulse count 2 or 4
• Designed for commercial application
• 5 year warranty

Enroll

by placing the panel into wireless enrollment mode
and tripping the sensor's enrollment sequence. Interlogix® ,
DSC®, Qolsys® and Cryptix™ variants can be enrolled by
pulling the battery tab or by tampering the unit. Honeywell
® and 2GIG™ variants can be enrolled by tripping the unit
three times (tamper or motion) or by holding the tamper
down and powering the unit up by pulling the battery
tab. Honeywell and 2GIG sensors must be enrolled as a
"Loop1" sensor. Alternatively, all variants of the motion
sensor can be enrolled by entering its serial number into the
panel.

Install

by screwing two #8 screws into the ceiling, leaving 1/4
inch of thread exposed. Next, slide the back plate over the
screws and rotate the back plate. Screw the third #8 screw
through the wall tamper into the ceiling, ensuring that the
wall tamper screw is attached to something solid. Tighten all
screws until snug. Then, insert the square nut into the square
slit of the cover and start threading the #4 screw into the
side of the cover. Close the cover and conduct a walk test.
After walk testing, take the unit out of walk test mode and
close the cover again. Finally, finish threading the #4 screw
until it is snug.

Mounting Tips

• Avoid direct sunlight
• Avoid facing directly to AC or heating vents
• Avoid vapor or high humidity
• Avoid curtains, screens, etc. from blocking detection
• Do not install outdoors
Use your panel's installation guide to verify proper system setup.
alarms when motion is sensed.
I