Resolution RE218 Quick Start Manual

RE218 Honeywell
Trident
is an integrated environmental sensor. It detects water
and reports extreme temperature conditions.

Features

• Titanium probes for unmatched corrosion immunity
• IP67 rated waterproof enclosure
• GORE® vent equalizes enclosure pressure
• 5 year warranty

Enroll

by placing the panel into wireless enrollment mode and
removing the battery tabs or tampering the sensor.

Loop Configuration

• Loop 1 = Heat
• Loop 2 = Flood
• Loop 3 = Freeze
• Loop 4 = Tamper

Install

by placing the sensor in the location requiring water or air
temperature detection. If desired, the wall clip can be used to
secure the Trident sensor.

Optional Wall Clip Securing

Optional Wall Clip Securing
• Remove the Trident body from wall clip. • Remove the Trident body from wall clip.
• Secure wall clip to a surface with a #6 mounting • Secure wall clip to a wall with a #6 screw.
• Example securing locations are a wall, baseboard screw.
• Example securing locations: wall, baseboard or or cupboard.
Detects water pooled under the sensor and reports extreme air
temperature conditions.

Temperature Trip Points

• Heat larms when over 100.4° F (38° C)
• Heat restores when under 96.8° F (36° C)
• Freeze alarms when under 44.6° F (7° C)
• Freeze restores when over 48.2° F (9° C)
To replace the battery, insert a flat blade screwdriver into the
front slot and twist. To reinstall the cover, align the rear latches
and roll the cover forward until it snaps into place.
Verify proper enrollment and operation using your control panel's installation manual.
® Compatible Trident ™ Environmental Sensor
I
Wall Clip
Mounting Screw Hole
Front slot