Setup; Connecting The Power Cable And Turning On The Projector - Digital Projection THUNDER 10000Dsx User Manual

3. SETUP

Connecting the Power Cable and Turning on the Projector

Before you turn on your projector, ensure that the computer or video source is turned on and that your lens cap is removed.
1. Connect the supplied power cable to the projector.
Plug the supplied power cable into the AC outlet.
2. Turn On The Projector
The main power switch is on the front panel of the projector.
By pushing up this switch, the projector will go into its standby mode and the POWER
indicator will glow orange. Only after you press the 'POWER ON' button on the remote
control or projector cabinet will the POWER indicator turn to green and the projector
will fully turn on.
O N
O F
3. Turn Off The Projector
First press the POWER OFF button on the remote control or the projector cabinet for a mini-
mum of two seconds. Allow the fan to cool the projector for three minutes.
This will extend the life of the lamp. After the cooling fan stops working, the POWER indicator
will change to a steady orange glow and the projector will be in the stand-by mode. Then turn
off the main power switch on the front panel. The POWER indicator will go out. If you desire to
move the projector then unplug the power cable.
O N
O F
F
NOTE: Immediately after turning on the projector, screen flicker may occur. This is not a fault. Wait 3 to 5
minutes until the lamp lighting is stabilized.
CAUTION: Do not turn off the main power while the cooling fan is working.
P O
W E
R
F
P O
W E
R
Note:
Projector power connector may vary depending upon country.
Currently USA model will be a "Twist-lock" and European model
will be a "C-form".
Open the cover of the
power cable to plug
fully into the AC IN on
the projector.
POWER
ON/OFF
STATUS
POWER
ON/OFF
STATUS
E – 11
To the wall outlet
[POWER] switch
[POWER] button
[POWER] indicator
POWER INPUT
1 2
ON OFF
ABC
4 5
TEST
JKL
7 8
IMAGE/ PROJECTOR
STU
ON
0
PICTURE WHITE BAL.
OFF
ADJUST
3
DEF GHI
6
MNO PQR
9
VWX YZ/