6.13 Disassembly of rail bracket, slider, automatic clean fender
6.12 Disassembly of rail bracket, slider, atomatic clean fender
Step1: Remove the door from oven (please refer to Point 6.3.1), and put it horizontally on the
table.
Step2: Remove the screws connected the rail bracket and the cavity, and take it out from
the clipping hole.
Step3: Remove the screws connected the slider and the rail bracket, and then disassemble
the slider.
Step4: Remove the screws connected the automatic clean fender and the cavity, and then
disassemble the fender.
29
23