Connecting Your Monitor : Prolite X2481Hs - Iiyama ProLite XB2481HS-B1 User Manual

CONNECTING YOUR MONITOR : ProLite X2481HS

Ensure that both the computer and the monitor are switched off.
Connect the computer to the monitor with the signal cable.
Connect the monitor to the audio equipment with the Audio Cable for computer when using the
audio features.
Connect the Power Cable to the monitor first and then to the power source.
Turn on your monitor and computer.
 The signal cables used for connecting the computer and monitor may vary with the type of
NOTE
computer used. An incorrect connection may cause serious damage to both the monitor
and the computer. The cable supplied with the monitor is for a standard connector. If a
special cable is required please contact your local iiyama dealer or regional iiyama office.
 For connection to Macintosh computers, contact your local iiyama dealer or regional
iiyama office for a suitable adaptor.
 Make sure you tighten the finger screws at each end of the signal cable.
 The Class I pluggable equipment Type A must be connected to protective earth.
 The socket-outlet shall be installed near the equipment and shall be easily accessible.
 Excessive sound pressure from ear-/headphones can cause hearing damage/hearing
loss.
[Example of Connection]
Power Cable
(Accessory)
* VGA cable is not supplied with the monitor. If you use low quality VGA cable, it may cause a result
of electro-magnetic interference. Please contact the iiyama Support Centre in your country if you
wish to connect the monitor via the VGA input.
[ Collect Cables ]
Put the cables through the Cable Holder to bundle them.
12 BEFORE YOU OPERATE THE MONITOR
<Back>
Audio Cable (Accessory)
VGA Cable (Not Included)*
DVI-D Cable (Accessory)
HDMI Cable (Not Included)
Computer
AV Equipment etc.