Connecting Your Monitor : Prolite E2008Hds / Prolite E2008Hdd - Iiyama ProLite B2008HDS-1 User Manual

CONNECTING YOUR MONITOR : ProLite E2008HDS / ProLite E2008HDD

Ensure that both the computer and the monitor are switched off.
Connect the computer to the monitor with the signal cable.
Connect the monitor to the audio equipment with the Audio Cable for computer when using the
audio features.
Connect the Power Cable to the monitor fi rst and then to the power supply.
Power of the monitor and the computer is turned on.
 The signal cables used for connecting the computer and monitor may vary with the type of
NOTE
computer used. An incorrect connection may cause serious damage to both the monitor and
the computer. The cable supplied with the monitor is for a standard 15 pin D-Sub connector.
If a special cable is required please contact your local iiyama dealer or regional iiyama
offi ce.
 For connection to Macintosh computers, contact your local iiyama dealer or regional
iiyama offi ce for a suitable adaptor.
 Make sure you tighten the fi nger screws at each end of the signal cable.
[Example of Connection]
Power Cable
(Accessory)
1
* Not included in the ProLite E2008HDD.
2
* Available for ProLite E2008HDS only.
[ Fitting and Removal of Cable Holder ]
Removal
Pull out the hook.
Hold the both sides of the hook, and remove one
tab at a time.
Fitting
Collect cables at the back of the stand.
Hold the both sides of the hook, and insert one tab
at a time into the holes.
<Back>
D-Sub Signal Cable
(Accessory)
DVI-D Cable (Accessory)*1
Audio Cable (Accessory)*2
BEFORE YOU OPERATE THE MONITOR 9
Computer