Panduit LS8E-KIT Operator's Manual page 33

SETTING UP THE PANTHER LS8E
AND USING FILE MANAGER
Label Modes
To edit the label mode, press the LABEL key.
1. Use the up or down directional arrows to select the desired mode and then
press .
Available Modes include:
MODE DESCRIPTION
Component Vertically centers legend
Wiremarker Repeats legend until label is filled
Terminal Places legends at terminal locations
Tape Rotates legends 90° clockwise
Strip Repeats legend until label is filled
and copies legend on two sides of
middle perforation
Network Places legends at port locations
Flag Prints legend once at top of label
and then repeats the legend once at
the bottom of label
Vertical Prints legend vertically
NOTE: Another mode for DIN terminal block labeling is accessible by pressing
the F5 key. DIN terminal block labeling is based on European standards
and is primarily used in European countries. For detailed instructions on
using the DIN mode, refer to the Labeling Exercises section of this
manual on page 57.
APPLICATIONS
Electrical components
Wire and cable marking
Terminal blocks
Safety/facility ID, pipe
marking
Wire and cable marking
Data communications
components
Wire and cable marking
Safety/facility ID, pipe
marking
33