Table of Contents
Advertisement
Getting
Safety
Started
Ethernet
Installation
Configuration
1
Position the mounting template on the surface where you intend to mount
the Data Gateway and secure in place with transparent tape.
2
Drill holes through the template in the specified locations for the mounting
screws. After drilling holes, remove the template from the surface.
3
If using drywall anchors, set them into the wall. Then, drive the screws into
the wall leaving a gap of about 1/8" (3 mm) between the screw head and
the wall. If not using anchors, just drive the screws.
4
Orient the Data Gateway with the indicator lights facing up or right, as de-
sired. Slip both mounting slots (in the back of the Data Gateway) over the
screws, then slide the case down until the narrow end of the keyhole slot
contacts the screw shaft.
5
Proceed to
Desktop mounting instructions
1
Position the Data Gateway so that:
•
air flows freely around it
•
the back faces the nearest wall
•
it will not fall to the floor if bumped or moved
•
the ventilation holes on the side of the unit are not blocked.
2
Proceed to
Touchstone DG860P2 Data Gateway User's Guide
Usage
Troubleshooting
Connecting the Data
Gateway.
Connecting the Data
Gateway.
Glossary
19
Advertisement
Table of Contents
