Basic Operating Set-Up-Windows Xp; Basic Setup Before Evaluation; Sound And Audio Devices Properties-Audio Tab (Windows Xp) - Texas Instruments DEM-PCM2912 EVM User Manual

www.ti.com
3.2 Basic Operating Set-Up—Windows XP
This section reviews how to set up the DEM-PCM2912 EVM for use with a PC equipped with the Microsoft
XP (including Service Pack 2 updates) operating system.
When the installation is complete, the EVM software is ready to use.

3.2.1 Basic Setup Before Evaluation

Follow these steps to set up the DEM-PCM2912 EVM for use with Windows XP.
Step 1. Connect the USB connector of the DEM-PCM2912 EVM to an available USB connector (or
hub) port on the lab PC. The DEM-PCM2912 EVM can be connected directly to the PC
without an additional USB cable.
After the EVM is connected to the PC, the standard Windows XP driver installs automatically
to the PC. A custom driver for the DEM-PCM2912 is unnecessary.
Step 2. Open the Control Panel from the Start menu (Start→Control Panel. Open the Sound and
Audio Devices group from the Control Panel.
Step 3. Select the Audio tab and confirm the USB audio codec appearance as the default playback
and recording device, as shown in
Figure 3-7. Sound and Audio Devices Properties—Audio Tab (Windows XP)
This process confirms the proper recognition of the DEM-PCM2912 EVM by Windows XP.
SBAU132 – March 2008
Submit Documentation Feedback
Basic Operating Set-Up—Windows XP
Figure 3-7.
Set-Up Guide 23