Download Print this page
Texas Instruments DEM-OPA-MSOP-1B User Manual

Texas Instruments DEM-OPA-MSOP-1B User Manual

Demonstration fixture

Advertisement

Quick Links

1
Description
The DEM-OPA-MSOP-1B demonstration fixture is an unpopulated printed circuit board (PCB) for single
2:1 multiplexers in MSOP-8 packages.
information on these op amps, and good PCB board layout techniques, see the individual amplifier data
sheets.
Figure 1. Buffer Pinout Compatible with DEM-OPA-MSOP-1B
All trademarks are the property of their respective owners.
SBOU044C – April 2007 – Revised April 2015
Submit Documentation Feedback
DEM-OPA-MSOP-1B Demonstration Fixture
Figure 1
Channel 0 (V0)
1
GND
2
Channel 1 (V1)
3
4
402W
-V
S
MSOP-10
Copyright © 2007–2015, Texas Instruments Incorporated
SBOU044C – April 2007 – Revised April 2015
shows the package pinout for this PCB. For more
8
+V
S
7
Chip Enable (
EN
)
6
Output (V
)
OUT
402W
5
Channel Select (SEL)
DEM-OPA-MSOP-1B Demonstration Fixture
User's Guide
1

Advertisement

loading
Need help?

Need help?

Do you have a question about the DEM-OPA-MSOP-1B and is the answer not in the manual?

Questions and answers

Summary of Contents for Texas Instruments DEM-OPA-MSOP-1B

  • Page 1 SBOU044C – April 2007 – Revised April 2015 DEM-OPA-MSOP-1B Demonstration Fixture Description The DEM-OPA-MSOP-1B demonstration fixture is an unpopulated printed circuit board (PCB) for single 2:1 multiplexers in MSOP-8 packages. Figure 1 shows the package pinout for this PCB. For more information on these op amps, and good PCB board layout techniques, see the individual amplifier data sheets.
  • Page 2 The circuit schematic in Figure 2 shows the connections for all possible components. 402W 402W Figure 2. Schematic for DEM-OPA-MSOP-1B Components Components that have RF performance similar to those listed in Table 1 may be substituted. Table 1. Component Descriptions...
  • Page 3: Board Layout

    If a high-impedance probe must be used, place a 100Ω resistor on the probe tip to isolate its capacitance from the circuit. SBOU044C – April 2007 – Revised April 2015 DEM-OPA-MSOP-1B Demonstration Fixture Submit Documentation Feedback Copyright © 2007–2015, Texas Instruments Incorporated...
  • Page 4 Rev. C - 01/09 PR1424 (a) Top layer (b) Bottom layer (negative image shown for clarity) Figure 3. DEM-OPA-MSOP-1B Demonstration Fixture Layout DEM-OPA-MSOP-1B Demonstration Fixture SBOU044C – April 2007 – Revised April 2015 Submit Documentation Feedback Copyright © 2007–2015, Texas Instruments Incorporated...
  • Page 5 STANDARD TERMS AND CONDITIONS FOR EVALUATION MODULES Delivery: TI delivers TI evaluation boards, kits, or modules, including any accompanying demonstration software, components, or documentation (collectively, an “EVM” or “EVMs”) to the User (“User”) in accordance with the terms and conditions set forth herein. Acceptance of the EVM is expressly subject to the following terms and conditions.
  • Page 6 FCC Interference Statement for Class B EVM devices NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
  • Page 7 【無線電波を送信する製品の開発キットをお使いになる際の注意事項】 開発キットの中には技術基準適合証明を受けて いないものがあります。 技術適合証明を受けていないもののご使用に際しては、電波法遵守のため、以下のいずれかの 措置を取っていただく必要がありますのでご注意ください。 1. 電波法施行規則第6条第1項第1号に基づく平成18年3月28日総務省告示第173号で定められた電波暗室等の試験設備でご使用 いただく。 2. 実験局の免許を取得後ご使用いただく。 3. 技術基準適合証明を取得後ご使用いただく。 なお、本製品は、上記の「ご使用にあたっての注意」を譲渡先、移転先に通知しない限り、譲渡、移転できないものとします。 上記を遵守頂けない場合は、電波法の罰則が適用される可能性があることをご留意ください。 日本テキサス・イ ンスツルメンツ株式会社 東京都新宿区西新宿6丁目24番1号 西新宿三井ビル 3.3.3 Notice for EVMs for Power Line Communication: Please see http://www.tij.co.jp/lsds/ti_ja/general/eStore/notice_02.page 電力線搬送波通信についての開発キットをお使いになる際の注意事項については、次のところをご覧くださ い。http://www.tij.co.jp/lsds/ti_ja/general/eStore/notice_02.page SPACER EVM Use Restrictions and Warnings: 4.1 EVMS ARE NOT FOR USE IN FUNCTIONAL SAFETY AND/OR SAFETY CRITICAL EVALUATIONS, INCLUDING BUT NOT LIMITED TO EVALUATIONS OF LIFE SUPPORT APPLICATIONS.
  • Page 8 Notwithstanding the foregoing, any judgment may be enforced in any United States or foreign court, and TI may seek injunctive relief in any United States or foreign court. Mailing Address: Texas Instruments, Post Office Box 655303, Dallas, Texas 75265 Copyright © 2015, Texas Instruments Incorporated...
  • Page 9: Important Notice

    IMPORTANT NOTICE Texas Instruments Incorporated and its subsidiaries (TI) reserve the right to make corrections, enhancements, improvements and other changes to its semiconductor products and services per JESD46, latest issue, and to discontinue any product or service per JESD48, latest issue.