Basic Operating Set-Up-Windows Vista; Basic Setup Before Evaluation; Sound-Playback Tab (Windows Vista); Sound-Recording Tab (Windows Vista) - Texas Instruments DEM-PCM2912 EVM User Manual

Basic Operating Set-Up—Windows Vista
3.1 Basic Operating Set-Up—Windows Vista
This section reviews how to set up the DEM-PCM2912 EVM for use with a PC equipped with the Microsoft
Vista Basic (or higher) operating system.
When the installation is complete, the EVM software is ready to use.

3.1.1 Basic Setup Before Evaluation

Follow these steps to set up the DEM-PCM2912 EVM for use with Windows Vista.
Step 1. Connect the USB connector of the DEM-PCM2912 EVM to an available USB connector (or
hub) port on the lab PC. The DEM-PCM2912 EVM can be connected directly to the PC
without an additional USB cable.
After the EVM is connected to the PC, the standard Windows Vista driver installs
automatically to the PC. A custom driver for the DEM-PCM2912 is unnecessary.
Step 2. Open the Control Panel from the Start menu (Start→Control Panel. Open the Sound group
from the Control Panel.
Step 3. Select the playback tab and confirm the USB audio codec appearance as the default
playback device, as shown in
Step 4. Select the recording tab and confirm the USB audio codec appearance as the default
recording device, as shown in
Figure 3-1. Sound—Playback Tab
(Windows Vista)
18 Set-Up Guide
Figure 3-1.
Figure 3-2.
Figure 3-2. Sound—Recording Tab
www.ti.com
(Windows Vista)
SBAU132 – March 2008
Submit Documentation Feedback