Disassembly Instructions - Mitsubishi Electric MUZ-AP VG Series Service Manual

11

DISASSEMBLY INSTRUCTIONS

<Detaching method of the terminal with locking mechanism>
The terminal which has the locking mechanism can be detached as shown below.
There are 2 types of the terminal with locking mechanism.
The terminal without locking mechanism can be detached by pulling it out.
Check the shape of the terminal before detaching.
(1) Slide the sleeve and check if there is a locking lever or not.
Sleeve
Locking lever
11-1. MSZ-AP25VG
MSZ-AP25VGK MSZ-AP35VGK MSZ-AP42VGK MSZ-AP50VGK
NOTE: Turn OFF the power supply before disassembly.
OPERATING PROCEDURE
1. Removing the front panel and the panels (R/L/F/U)
Removing the front panel (Photo 1, Figure 1)
(1) Lift the front panel until a "click" is heard.
(2) Hold the hinges and pull to remove the front panel
(Figure 1).
(3) Remove the horizontal vanes.
Unlock the stopper and remove the horizontal vanes
using following tool like a screw driver.
Unlock
OBH788C
Slide the sleeve.
Pull the terminal while
pushing the locking
lever.
MSZ-AP35VG MSZ-AP42VG
Upper
Lower
(2) The terminal with this connector shown below
has the locking mechanism.
Hold the sleeve, and
pull out the terminal
slowly.
Connector
MSZ-AP50VG
: Indicates the visible parts in the photos/figures.
: Indicates the invisible parts in the photos/figures.
PHOTOS/FIGURES
Photo 1
Front panel
Horizontal vane (L)
Figure 1
45
Horizontal vane (U)
Hinge
Hole