Mitsubishi Electric MUZ-AP VG Series Service Manual page 51

11-2. MSZ-AP60VG
MSZ-AP60VGK
NOTE: Turn OFF the power supply before disassembly.
OPERATING PROCEDURE
1. Removing the panel
(1) Remove the horizontal vanes.
(2) Remove the screw caps of the panel. Remove the
screws of the panel.
(3) Hold the lower part of both ends of the panel and pull
it slightly toward you, and then remove the panel by
pushing it upward.
2. Removing the Wi-Fi interface (Photos 3, 4)
MSZ-AP VGK
∙
(1) Remove the front panel, the panel and the right corner
box.
(2) Remove the Wi-Fi interface on the right side of the
panel (F). Pull out its cable, and remove the cable tie,
then remove the panel (F).
(3) Remove the screw of the V.A. clamp and remove the
V.A. clamp.
(4) Remove the screw of the electrical cover, and remove
the electrical cover.
(5) Disconnect the following connector (Photo 4):
<Indoor electronic control P.C. board>
CN110 (Wi-Fi interface)
(6) Remove the cable of the Wi-Fi interface from the
water cover.
(7) Remove the lead wire of the Wi-Fi interface from the
hook of the cable guide.
How to install the Wi-Fi interface
Note: Install the Wi-Fi interface before installing the panel.
(1) Install the panel (F).
(2) Fasten the cable of the Wi-Fi interface to the part
of the panel with a cable tie.
(3) Stow the cable of the Wi-Fi interface in the area
(4) Attach the Wi-Fi interface so that its cable is facing
away from you on the right side.
(5) Fasten the cable of the Wi-Fi interface to the water
cover.
(6) Attach the lead wire of the Wi-Fi interface to the
hook of the cable guide.
(7) Connect the connector of the Wi-Fi interface
(CN110) to the indoor electronic control P.C.
board.
(8) Install the electrical cover, and install the screw in
the electrical cover.
(9) Install the V.A. clamp, and install the screw in the
V.A. clamp.
OBH788C
MSZ-AP71VG
MSZ-AP71VGK
(Photo 3)
PHOTOS/FIGURES
Photo 1
Horizontal vanes
Screws of the panel
Photo 2
Screws of the panel
.
51
Front panel