Table of Contents
Advertisement
Hard drive
NOTE:
The hard drive spare part kit does not include the hard drive bracket or screws.
Description
750-GB, 7200-rpm, 9.5-mm
500-GB, 7200-rpm, 9.5-mm SED
500-GB, 7200-rpm, 9.5-mm
320-GB, 7200-rpm, 9.5-mm
Hard Drive Hardware Kit (includes hard drive bracket and screws)
Before removing the hard drive, follow these steps:
1.
Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2.
Disconnect the power from the computer by unplugging the power cord from the computer.
3.
Disconnect all external devices from the computer.
4.
Remove the battery (see
5.
Remove the service cover (see
6.
Remove the Smart Card reader (see
Remove the hard drive:
1.
Loosen the three Phillips screws (1) that secure the hard drive to the computer.
2.
Use the hard drive tab (2) to slide the hard drive to the right to disconnect it from the
system board.
80
Chapter 4 Removal and replacement procedures
Battery on page
71).
Service cover on page
Smart Card reader on page
Spare part number
633252-001
683801-001
634925-001
634862-001
642774-001
74).
75).
Advertisement
Table of Contents
