2.
Detach the RTC battery (2) from the TouchPad. (The RTC battery is attached to the TouchPad with
double-sided tape.)
3.
Remove the RTC battery.
Reverse this procedure to install the RTC battery.
Display lid switch board
Description
Display lid switch board (includes cable)
Before removing the display lid switch board, follow these steps:
1.
Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2.
Disconnect the power from the computer by unplugging the power cord from the computer.
3.
Disconnect all external devices from the computer.
4.
Remove the battery (see
a.
Service cover (see
b.
Smart Card reader (see
c.
Optical drive (see
d.
Hard drive (see
e.
Modem module (see
f.
Keyboard (see
g.
Base enclosure (see
110
Chapter 4 Removal and replacement procedures
Battery on page
71), and then remove the following components:
Service cover on page
Smart Card reader on page
Optical drive on page
Hard drive on page
80)
Modem module on page
Keyboard on page
91)
Base enclosure on page
74)
75)
76)
89)
96)
Spare part number
684340-001