Summary of Contents for U-Line Presto Lifts P3 All Around
Page 1
P3 All Around Pallet Positioner Installation, Operation and Service Manual Serial # _____________________________ Date placed in service _________________ IMPORTANT: READ CAREFULLY BEFORE INSTALLING OR OPERATING LIFT Part orders are subject to a $50 net minimum charge. NOV 2017 H-1820 PAGE 1 OF 18 0721 IH-1820VND...
Page 2
This manual was current at the time of printing. To obtain the latest, most updated version, please contact the Customer Service Department or go to our website: www.PrestoLifts.com -- you will find a complete list of current owner’s manuals to print. H-1820 P3 ALL AROUND - PRESTO PALLET POSITIONER PAGE 2 OF 18...
INTRODUCTION The P3 All Around Pallet Positioner is a simple device that will automatically maintain a load at the ideal height for manual loading and unloading. If a palletized load is placed on the unit, the unit gradually rises as boxes or parts are removed. This automatically maintains the top of the load at the correct working height.
Responsibility of Owners and Users Inspection and Maintenance The device shall be inspected and maintained in proper working order in accordance with Presto Lifts owner’s manual. Removal from Service Any device not in safe operating condition such as, but not limited to, excessive leakage, missing rollers, pins, or fasteners, any bent or cracked structural members, cut or frayed pneumatic lines, damaged or malfunctioning controls or safety devices, etc.
SAFETY ALERT SYMBOLS AND SIGNAL WORDS The safety of all persons operating, maintaining, repairing, or in the vicinity of this equipment is of paramount concern. This is a powerful machine with moving parts, and is capable of causing personal injury if proper precautions are not taken. Therefore, throughout this manual, certain hazards have been identified which may occur in the use of the machine, and there are appropriate instructions or precautions which should be taken to avoid these hazards.
Page 7
WARNING! Do not inflate the system to more than 30 PSI at the fully raised position with no load. If the actuation system pres- sure is higher than 65 PSI under any circumstance it may cause the failure of the air actuation system thus resulting in severe injury.
Unpacking the Unit 1. Before you put the unit in service, check for local codes and ordinances that may apply. It is your responsibility to obtain any necessary permits. 2. Please read all of these instructions carefully. Be sure to read and understand all of the warn- ings.
Figure A AIR PRESSURE GAUGE AIR PRESSURE MANIFOLD RELIEF VALVE VALVE VALVE STEM MANUAL AIR FOR AIR FILL DISCHARGE VALVE OPERATION NOTES WARNING! Never sit or ride on the turntable or operate the unit if anyone is on it. WARNING! Never operate the unit if the load is off center.
Specifications Imperial Metric Load capacity 300 to 4500 lbs. 180kg to 2025kg Load size 50" x 50" l x 72" high 1270mm x 1270mm x 1800mm high Base frame 36" x 36" 915mm x 915mm Compressed height 9-1/2 inches 240mm Extended height 27-3/4 inches 705mm...
Page 11
Item 10089457 Item 10089457 THIS DRAWING MUST BE AT REVISION: '-' Item 10089458 Item 2990414 ECOA Figure 1. H-1820 Decal 30000568 PAGE 11 OF 18 0721 IH-1820VND P3 ALL AROUND - PRESTO PALLET POSITIONER...
OPERATING INSTRUCTIONS (continued) WARNING! Ensure that loading and unloading of the P3 All Around is done in even layers. Loading or unloading a load on one side may cause the load to tip over and you may be injured. This can also damage the unit. See Figure 4. Figure 2.
Figure 5. Loading with a Fork Lift Loading with a Fork Lift 1. Place the evenly layered load on the unit. Be sure the load is centered on the turntable, then slowly lower the fork lift. • Lower the load until the airbag on the P3 All Around is fully compressed.
2 When equipped with the optional Portability Set release the floor lock and move the unit. Be sure to engage the floor lock once the P3 All Around is re-located. 3. When equipped with the optional leveling feet the base frame can be raised approximately 3'' from the floor allowing access for a hand (or pow- ered) pallet jack to be positioned under the center of the base frame.
Maintenance • The lack of maintenance may result in catastrophic failure. • See Figure 8 on page 14: Safe Servicing of the Lift before performing maintenance. Routine Periodic Maintenance Every 90 days - • Inspect all rollers, pins and bushings for excessive wear. >...
Ordering Replacement Parts Presto has carefully chosen the components in your unit to be the best available for the purpose. Replacement parts should be identical to the original equipment. Presto will not be responsible for equipment failures resulting from the use of incorrect replacement parts or from unauthorized modifications to the unit. Presto can supply all replacement parts for your PalletPal.
Presto Lifts Limited Warranty Policy Presto Lifts warrants this product against defects in the welded structural frame and, including the scissor legs from faulty material and workmanship for a period of five years from the date of invoice. A lifetime limited warranty is provided for the Airstroke Actuator in all pneumatic lifts against any defect due to faulty material or workmanship.