Table of Contents
Advertisement
Configure the Calibrator
POWER SWITCH to "SOURCE" or
Move
w
"READ".
MODEL 54#B V#.##
DOUBLE CLICK
EZ-DIAL KNOB
FOR CONFIGURATION
Setup
Double click the
e
unit is on and the following displays will appear
for 15 seconds:
> EXIT
TEMP UNITS
T/C
AUTO OFF
Turn the
e
DIAL KNOB to move through the
menu. Press the
between OFF and ON or to scroll through the
settings.
Simulating thermocouples requires the use of
thermocouple or extension grade thermocouple
wire.
Plug thermocouple wires into the female
miniature thermocouple connector mounted in
the top end of the housing.
The CL540A/CL540ZA has two banana jacks
mounted in the top end of the housing. These
are not temperature compensated and are to be
used only for millivolt signals.
Configuration
DIAL KNOB at any time the
15
°C
K
ON
e
DIAL KNOB to toggle
EXIT MENU - exits this menu immediately and
saves any changes. Menu will automatically exit
after 15 seconds of inactivity (countdown timer is
displayed).
TEMP UNITS - pressing the knob will toggle
between °C and °F.
T/C -
CL540A: pressing the knob will toggle between
the factory configured T/C Type and mV.
CL540ZA: pressing the knob will cycle through
T/C types J, T, E, K, R, S, B, N, G, C, D, L
(J-DIN), U (T-DIN), Platinel II and mV.
AUTO OFF - If AUTO OFF is ON, the unit will
turn off after 30 minutes of inactivity to save
battery life. If AUTO OFF is OFF the unit will stay
on until the POWER SWITCH is moved to the off
position.
Note: All settings are remembered even with the
power off. Removing the batteries resets the
values to factory defaults.
Connections
Thermocouple Wire
THERMOCOUPLE SOURCE
HI
322.1
TYPE K °C
TYPES
J T E K R S B N G C D L U P m V
SOURCE
HI
SET
OFF
LO
Push & Turn
for
Fast Dialing
Push & Hold
to
Store/Ramp
Double Click
for Options
(Optional Boot Shown)
Device
Requiring
Calibration
Page 3
Advertisement
Table of Contents
