Table of Contents
Advertisement
Copying Parameters Between Switches:
The 232BSS4 setup software can save configuration data to a file for
copying of parameters. Any unit's setup can be copied by first reading
the data from one switch, then saving to another.
Step 1:
Step 2:
Step 3:
Select Single Unit operation. If the configuration to be used
is already saved to a file, skip to Step 8.
Step 4:
Connect the switch to be copied to the serial (COM) port of
the PC. Install the setup jumper. Apply power to the
232BSS4.
Step 5:
Step 6:
Select Save As from the File menu. Save the configuration to
disk.
Step 7:
Step 8:
Connect the destination switch to the serial (COM) port of
the PC. Install the setup jumper. Apply power to the
232BSS4.
Step 9:
Select File/Load File and load the saved configuration.
Step 10:
Once the configuration file has been loaded, any number of switches can
be set to the same parameters by connecting and configuring each in turn.
Default Parameters:
When shipped, the 232BSS4 comes set up for the following
parameters:
Auto Select mode OFF
DTR NOT required to accept commands
THREE-character command
Char1 = ESC (Decimal 27)
Char2 = STX (Decimal 2)
Char3 = "0" (Not Used)
Port Time = 1,000 mS (Not Used)
Inactivity Time = 500 mS (Not Used)
All ports 9600 Baud
All ports 8 Data Bits
All ports No Parity
All ports No Hardware Handshake required
Ports A-D No preamble
Port A selected to Transmit & Receive on Power-up
Documentation Number 232BSS4 0812 Manual
Run the setup software.
Select serial (COM) port to be used for programming.
Click Next.
Disconnect the first 232BSS4 from the COM port.
Click Save Changes
29
Advertisement
Table of Contents
