3: Adding To Z-Wave Network - FIBARO FGTSP-001 Operating Manual

#3: Adding to Z-Wave network

Adding (Inclusion) - Z-Wave device learning mode, allowing to add
the device to existing Z-Wave network.
To add the device to the Z-Wave network:
1. Make sure the device is within the direct range of your Z-Wave
controller.
2. Set the main controller in (security/non-security) add mode (see
the controller's manual)
3. Use the included key to quickly triple click the button on the ther-
mostatic head.
4. The LED ring will start blinking white.
5. If you are adding in S2 authenticated mode, type in the device pin
code (underlined part of the public key on the label).
6. Wait for the adding process to end.
7. Successful adding will be confirmed by the Z-Wave controller.
ADDING TO Z-WAVE NETWORK
5