Copying From The Bypass Tray - Gestetner 2235 Copy Manual

AdonisC2_ENcopy122F_FM.book Page 60 Thursday, February 15, 2001 3:23 PM
Copying

Copying from the Bypass Tray

Use the bypass tray to copy onto OHP
transparencies, adhesive labels, trans-
lucent paper, postcards, and copy pa-
per that cannot be set in the paper
tray.
2
Note
❒ The machine can automatically de-
tect the following sizes as standard
size copy paper:
Metric
A3L, A4L, A5L, 8
version
Inch A3L, 11" × 17"L, 8
version
1
8 /
2
❒ If you do not use the standard size
copy paper, you should input ver-
tical and horizontal dimensions.
The sizes that you can input are as
follows:
Metric • Vertical: 100 – 297mm
version
• Horizontal: 148 – 600mm
Inch • Vertical: 3.9" – 11.6"
version
• Horizontal: 5.8" – 23.4"
❒ When using paper larger than 433
mm in size, set it so that it is fed
straight into the machine.
❒ When using paper larger than 433
mm in size, the paper may become
wrinkled, and may not be fed into
the machine, or may cause paper
jams.
❒ To make copies onto OHP trans-
parencies or thick paper exceeding
2
128g/m , 35 lb., specify the paper
type in ⇒ P.63 "When Copying onto
OHP Transparencies or Thick Paper".
❒ The maximum number of sheets
you can set at a time depends on
the paper type. For details about
paper capacity of the bypass tray,
⇒ P.22 "Copy Paper".
60
" × 13"L
1
/
2
" × 14"L,
1
/
2
" × 11"L, 5 " × 8
1 1
/ / "L
2 2
A
Open the bypass tray.
B
Adjust the guides to copy paper
size.
Important
❒ If the guides are not flush with
the copy paper, a skew image or
paper misfeeds might occur.
C
Lightly insert the copy paper face
up until the beeper sounds.
The k indicator on the display au-
tomatically goes on.
1.
Extender
Note
❒ The face side of the paper set is
copied on.
❒ Do not stack paper over the lim-
it mark, otherwise a skew image
or paper misfeeds might occur.