Page 1
, LLC ® Form No. SJ-SJ624E-RM-880E-V1 THANKS YOUR PURCHASE OF A REMANUFACTURED PRODUCT. To make sure you get the most out of your product, be sure to register online at snowjoe.com to enjoy full product support. PASTE UPC LABEL HERE...
® ® (i.e. upper and lower water pipes, radiators, ranges, 1-866-SNOWJOE. refrigerators, microwave ovens and outer frames of heating equipment). Take necessary precautions to avoid electric shock. There is an increased risk of electric shock if your body is earthed or grounded.
Electrical Safety 4. To prevent the appliance cord from disconnecting from the extension cord during operation, make a knot with the two 1. Ground fault circuit interrupter (GFCI) protection should cords as shown in Table 1. be provided on the circuit(s) or outlet(s) to be used for the snow thrower.
Page 4
• Noise control – When using the snow thrower, you must When stepping backwards, be careful to avoid obstacles beneath your feet or behind you to avoid falling. respect local laws and regulations regarding noise control and environmental protection. To avoid noise disturbance, 7.
Safety Symbols The following table describes safety symbols that may appear on this product. Read, understand and follow all instructions on the machine before attempting to assemble and operate. Descriptions Symbols Symbols Descriptions READ THE OPERATOR'S MANUAL(S) – Read, understand WARNING! Do not expose the and follow all instructions in the unit to rain or wet conditions.
Know Your Electric Snow Thrower Read the owner’s manual and safety rules carefully before operating your electric snow thrower. Compare the illustration below to the actual unit in order to familiarize yourself with the location of the various controls and adjustments. Save this manual for future reference.
If any damage is seen or suspected, do not assemble. Instead, contact the Snow Joe + Sun Joe customer Fig. 3 ® ® service center at 1-866-SNOWJOE (1-866-766-9563) for assistance. Handle with care during assembly so that electrical wiring does not become damaged.
Page 8
4. Secure the upper handle to the handle brackets with NOTE: Loosen or tighten the crank adjustment knob as the knobs and carriage bolts. Make sure the knobs are needed to allow for smooth control of the crank rod. tightened (Fig. 4). Fig.
Fig. 12 Fig. 10 Discharge Chute Assembly 3. Secure the carriage bolts and knobs. Make sure to tighten the knobs (Fig. 13). 1. Remove the knobs, washers and carriage bolts from the discharge chute (Fig. 11). Fig. 13 Fig. 11 Operation NOTE: Before using this machine, make sure that the power 2.
® Snow Joe + Sun Joe customer service center at ® ® 1-866-SNOWJOE. Powering On and Off 3. Insert the female end of the extension cord into the WARNING! The auger starts rotating immediately appliance's polarized male plug (Fig. 15). after the snow thrower is switched on. Keep hands and feet away from the auger.
Page 11
Moving the Machine and Plowing 10. When working on pebbles, gravel or unpaved surfaces, avoid throwing loose surface material along with the snow the Snow by pushing down on the handle to raise the scraper bar at the base of the unit above the pebbles or gravel. 11.
1. The discharge chute can be adjusted 180 degrees by rotating the chute crank. Rotate the chute control crank WARNING clockwise to move the discharge chute to the left and counterclockwise to move the chute to the right (Fig. 19). Make sure that the chute deflector snaps and locks completely onto the discharge chute.
6. To protect the snow thrower from corrosion when storing 3. Install the other rubber plate in the same manner (Fig. 23). for long periods, lightly oil the metal parts. 7. Store the appliance in a dry and high or locked area out of Fig.
Page 14
1. Open the left side plate by removing three screws 4. Use your right hand to press the belt with ribbed side (Fig. 26). down. While holding the belt down with your right hand, use your left hand to turn the auger forward so that the auger pulley rotates in a clockwise direction.
Service and Support If your Snow Joe SJ624E-RM electric snow thrower requires ® service or maintenance, please call 1-866-SNOWJOE 2. Secure the auger. Using an 18 mm hex socket, turn the (1-866-766-9563) for assistance. pulley clockwise to remove (Fig. 31).
Page 16
Optional Accessories WARNING! ALWAYS use only authorized Snow Joe + Sun Joe replacement parts and accessories. NEVER use ® ® replacement parts or accessories that are not intended for use with this electric snow thrower. Contact Snow Joe + Sun Joe ®...
Page 19
We’re here to help Monday through Friday from 9AM to 6PM EST. You can reach us at 1-866-SNOWJOE (1-866-766-9563), online EXCLUSIONS: at snowjoe.com, via email at help@snowjoe.com or tweet us • Wearing parts like belts, augers, chains and tines are @snowjoe.
Need help?
Do you have a question about the SUNJOE SJ624E-RM and is the answer not in the manual?
Questions and answers