Table of Contents
Advertisement
Quick Links
OPERATOR'S MANUAL
A Division of Snow Joe
, LLC
®
THANKS
OF A REMANUFACTURED PRODUCT.
To make sure you get the most out of
your product, be sure to register online at
ELECTRIC SNOW THROWER
R
21-INCH | 15-AMP | LED LIGHT
Model SJ625E-RM
FOR
snowjoe.com
to enjoy full product support.
YOUR
PASTE UPC LABEL HERE
Form No. SJ-SJ625E-RM-880E-V1
PURCHASE
Advertisement
Table of Contents
Related Manuals for SNOWJOE SJ625E-RM
Summary of Contents for SNOWJOE SJ625E-RM
- Page 1 21-INCH | 15-AMP | LED LIGHT OPERATOR’S MANUAL Model SJ625E-RM A Division of Snow Joe , LLC ® Form No. SJ-SJ625E-RM-880E-V1 THANKS YOUR PURCHASE OF A REMANUFACTURED PRODUCT. To make sure you get the most out of your product, be sure to register online at snowjoe.com...
-
Page 2: General Safety Warnings
OPERATOR’S MANUAL Model SJ625E-RM A Division of Snow Joe , LLC ® Form No. SJ-SJ625E-RM-880E-V1 IMPORTANT! 6. Do not abuse the cord. Keep the cord away from heat, oil, sharp edges or moving parts. Never carry the snow Safety Instructions thrower by its cord or yank the cord to disconnect it from the electrical outlet. -
Page 3: Electrical Safety
SJTW-A 14-gauge 50-foot extension cord ® unpaved surfaces unless the snow thrower is adjusted for with lighted end (Model PJEXT50-B). Visit snowjoe. such surfaces according to the instructions given in this com to purchase this extension cord online or, to order operator’s manual. - Page 4 7. If the snow thrower strikes any object, immediately • Noise control – When using the snow thrower, you must stop the snow thrower, then inspect for damage – respect local laws and regulations regarding noise control Repair any damage before restarting and operating the and environmental protection.
-
Page 5: Safety Symbols
Safety Symbols The following table describes safety symbols that may appear on this product. Read, understand and follow all instructions on the machine before attempting to assemble and operate. Symbols Descriptions Symbols Descriptions READ THE OPERATOR'S MANUAL(S) – Read, understand WARNING! Do not expose the and follow all instructions in the unit to rain or wet conditions. -
Page 6: Technical Data
Know Your Electric Snow Thrower Read the owner’s manual and safety rules carefully before operating your electric snow thrower. Compare the illustration below to the actual unit in order to familiarize yourself with the location of the various controls and adjustments. Save this manual for future reference. -
Page 7: Carton Contents
If any damage is seen or suspected, do not assemble. Instead, contact the Snow Joe + Sun Joe customer ® ® service center at 1-866-SNOWJOE (1-866-766-9563) for assistance. Handle with care during assembly so that electrical wiring does not become damaged. - Page 8 Chute Crank Assembly Fig. 6 1. Remove the cotter pin from the crank rod (Fig. 3). Fig. 3 Cotter pin 3. Secure the crank rod in place with the cotter pin (Figs. 7 – 8). 2. Install the crank rod through the center plate and insert Fig.
-
Page 9: Discharge Chute Assembly
Discharge Chute Assembly 2. Secure the carriage bolts and knobs. Make sure the knobs are tightened (Fig. 13). 1. Position the chute deflector over the discharge chute and align the holes, placing the washer between the deflector Fig. 13 and the chute (Figs. 9 – 10). Fig. -
Page 10: Powering On And Off
3. Insert the female end of the extension cord into the 1. To switch the snow thrower ON, press the safety switch appliance's polarized male plug (Fig. 13). button, then squeeze the switch bar lever (Fig. 15). Fig. 15 Fig. 13 Switch bar lever Extension cord... - Page 11 Moving the Machine and Plowing the 10. When working on pebbles, gravel or unpaved surfaces, avoid throwing loose surface material along with the snow Snow by pushing down on the handle to raise the scraper bar at the base of the unit above the pebbles or gravel. 11.
-
Page 12: General Maintenance Tips
1. The discharge chute can be adjusted 180 degrees by rotating the chute crank. Rotate the chute control crank WARNING clockwise to move the discharge chute to the left and counterclockwise to move the chute to the right (Fig. 19). Make sure that the chute deflector snaps and locks completely onto the discharge chute. - Page 13 6. To protect the snow thrower from corrosion when storing 3. Install the other rubber plate in the same manner (Fig 23). for long periods, lightly oil the metal parts. 7. Store the appliance in a dry area out of reach of children. Fig.
-
Page 14: Replacing The Belt
Replacing the Belt 4. Use your right hand to press the belt with the ribbed side down. While holding the belt down with your right hand, NOTE: Under normal operating conditions, it should not be use your left hand to turn the auger forward so that the auger pulley rotates in a clockwise direction. -
Page 15: Service And Support
Service and Support 2. Secure the auger. Using an 18 mm hex socket, turn the pulley clockwise to remove (Fig. 31). If your Snow Joe SJ625E-RM electric snow thrower requires ® service or maintenance, please call 1-866-SNOWJOE Fig. 31 (1-866-766-9563) for assistance. - Page 16 NOTE: Accessories are subject to change without any obligation on the part of Snow Joe + Sun Joe to provide notice of such ® ® changes. Accessories can be ordered online at snowjoe.com or via phone by contacting the Snow Joe + Sun Joe customer ® ®...
- Page 17 We’re here to help Monday through Friday from 9AM to 6PM EST. You can reach us at 1-866-SNOWJOE (1-866-766-9563), online EXCLUSIONS: at snowjoe.com, via email at help@snowjoe.com or tweet us • Wearing parts like belts, augers, chains and tines are @snowjoe.
- Page 18 WARNING! This product or its power cord contains chemicals, including lead, known to the State of California to cause cancer and birth defects or other reproductive harm. Wash hands after handling. For more information go to www.P65Warnings.ca.gov. WARNING! Some dust created by power sanding, sawing, grinding, drilling, and other construction activities contains chemicals known [to the State of California] to cause cancer, birth defects, or other reproductive harm.
Need help?
Do you have a question about the SJ625E-RM and is the answer not in the manual?
Questions and answers
Hello I would like to know where I can get a new pulley drive for my sj625e because I can't find it anywhere mine is broken
You can purchase a replacement pulley drive for the SNOWJOE SJ625E-RM at snowjoe.com or by calling 1-866-SNOWJOE (1-866-766-9563).
This answer is automatically generated
@Mr. Anderson
Not available at retailer Snow Joe impossible to find
The Snow Joe SJ625E-RM is available for purchase at JOE's Factory Outlet. You can order it online at joesfactoryoutlet.com. Options include store pickup (within 1-5 days), free shipping to home (ships within 24 hours), or local delivery within 10 miles of Lodi, NJ, for $99.
This answer is automatically generated