Maintenance - Black & Decker BDGL2218 Original Instructions Manual

ENGLISH
Caution: Make sure the abrasive
wheel is completely stopped before
putting down the tool.
Rotating the Gear Case (fig. E)
The gear case is mounted onto the tool
casing, and it can be rotated to give the
user a more comfortable experience while
cutting.
The rotating gear case can be turned 90
degrees, 180 degrees, and 270 degrees to
the left or to the right.
• Loosen the four screws on the gear case.
• Rotate the gear case till it reaches its
ideal location.
• Tighten the four screws on the gear case.
• Ensure that the rotating mechanism is
locked.
Warning: Do NOT use the tool when
the gear case is unlocked.
Application on Metals
When applying the tool on metals, make
sure that a residual-current device (RCD) is
inserted to prevent danger from metal
chips. If the RCD causes power
disconnection, have the tool sent to an
authorized BLACK+DECKER dealer for
repair.
Warning: Under extreme working
conditions, conductive dust and grit
may accumulate on the housing
interior when handling metal workpieces.
This could create an electric shock hazard
as it weakens the protective insulation in
the grinder. To avoid accumulation of metal
chips in the interior of the grinder, we
recommend cleaning the ventilation ducts
daily. Refer to Maintenance.
Using Grinding Wheels
Warning: Metal powder accumulates.
Excessive use of the grinding wheel
on metals may increase the risk of
electric shock. To reduce the risk,
insert the RCD before use and clean the
ventilation ducts daily. Follow the
maintenance instructions below to blow dry
compressed air into the ventilation ducts.
12
(Original instructions)

Maintenance

BLACK+DECKER power tools have been
designed to operate over a long period of
time with minimal maintenance. Continuous
satisfactory operation depends upon proper
tool care and regular cleaning.
Warning: To minimize the danger of
serious personal injury, please
switch o the tool power and
disconnect all plugs before adjusting or
removing/installing any accessory. Before
reassembling the tool, press and release the
trigger switch to make sure the tool is
already switched o .
Lubrication
This power tool does not require separate
lubrication.
Cleaning
Warning: Once visible dust
accumulates on the ventilation ducts
and the surrounding, immediately
use dry air to blow away dust and grit out of
the interior of the housing. You need to
wear approved eye and facial protective
gear when performing this process.
Warning: Never use solvents or harsh
chemicals to clean non-metal parts of
the tool. These chemicals may
weaken the material of the parts. Use only
mild soap and damp cloth to clean the tool.
Never let any liquid get inside the tool;
never immerse any part of the tool into
liquid.
Accessories
Warning: Excluding accessories
provided by BLACK+DECKER, all
other accessories have not been
tested for product compatibility. Using such
accessories together with this tool may
cause safety hazards. To minimize the risk of
personal injury, we recommend you to use
only BLACK+DECKER accessories with this
product. Please inquire at your dealer for
more information regarding suitable
accessories.