Advertisement
Dimmer Setup
+
The LEDsmart
rotary dimmer has a number of useful functions which can easily be set up by entering setup mode and following
four easy steps.
It is recommended that the MINIMUM BRIGHTNESS is always set up. The other settings are optional, depending on the
dimmer application. To set the minimum brightness now, go to the next page.
Dimmer Setup Functions
Function
Entering Setup Mode
Setting Minimum Brightness
Setting Maximum Brightness
Setting the Kick Start Feature
Setting Off State LED Feature
Setting Separate Switch Mode
Setting Toggle / Memory Dimmer
Setting MultiMate™ Mode
Factory Defaults Reset
A: Entering Setup Mode
Before starting to setup the dimmer, the rotary dial should be removed by pulling it off the
shaft. This allows the white LED indicator to be easily seen during setup.
If the dimmer has been powered up for LESS THAN 15 MINUTES see A1.
If the dimmer has been powered up for MORE THAN 15 MINUTES see A2.
Once in Setup Mode, options are selected by a series of 'clicks' of the dimmer rotary
shaft. Each 'click' should be within 1 second of the previous click.
See Part
A
B
C
D
E
F
G
H
I
Setup Functions - Rotary Dimmer/Switch
2
Advertisement
