Advertisement
B: Setting Minimum Brightness
The minimum brightness level provided by the dimmer can be set to suit specific lamps and/or customer
requirements.
For the majority of lamps a minimum level as low as 0% can be set if required. However, some lamps can become
unstable at low dimming levels, in particular CFL's.
If lamps become unstable at low dimming levels, they typically flicker or pulse on/off. The dimmer allows the
minimum brightness to be set to a level above the point at which the lamp flickers/pulses.
Step 1
Enter into the dimmer Setup Mode - See PART A
Step 2
Click the dimmer rotary shaft twice
Step 3
LED will blink 2 times
Note: To cancel/exit do nothing for 30 seconds
Note: If more than one dimmer is connected to the same load, all dimmers connected
to this load will now blink 2 times
Step 4
Adjust dial to required MINIMUM brightness level
Note: If more than one dimmer is connected in parallel (see pages 5-7), wait for 3
seconds for the other connected dimmer to learn the new minimum level
Note: To cancel/exit do nothing for 30 seconds
Step 5
Click once to save & exit
Note: If more than one LEDsmart
brightness levels only needs to be set in one device. The setting is automatically saved
to all other devices connected in parallel
+
device is connected in parallel, the minimum
Setup Functions - Rotary Dimmer/Switch
4
Advertisement
