Advertisement
G: Setting Toggle / Memory
Step 1
Enter into the dimmer Setup Mode - See PART A
Step 2
Click the dimmer rotary shaft 7 times
Step 3
LED will blink 7 times
a.
If the memory dimmer function is currently Disabled, lamp(s) connected to
the dimmer will now turn OFF
b. If the memory dimmer function is currently Enabled, lamps(s) connected
to the dimmer will now turn ON
Note: To cancel/exit do nothing for 30 seconds
Note: If more than one dimmer is connected to the same load, all dimmers connected
to this load will now blink 7 times
Step 4
To Enable the memory dimmer adjust the dial Clockwise until the lamp(s) turns ON
To Disable the memory dimmer (Default) adjust the dial Anti-clockwise until the lamp(s)
turns OFF
Note: To cancel/exit do nothing for 30 seconds
Step 5
Click once to save & exit
Note: If more than one LEDsmart
brightness levels only needs to be set in one device. The setting is automatically saved
to all other devices connected in parallel
+
device is connected in parallel, the minimum
Setup Functions - Rotary Dimmer/Switch
9
Advertisement
