Advertisement
C: Setting Maximum Brightness
The maximum brightness level provided by the dimmer can be set to suit customer requirements.
Note that when lamps are dimmed near to full brightness, it is difficult to see changes in dimming level. Therefore,
when setting up maximum brightness, it is recommended that the lamp is slowly dimmed up to a point where no
further changes in brightness can be seen, and the maximum level set at this point.
Step 1
Enter into the dimmer Setup Mode - See PART A
Step 2
Click the dimmer rotary shaft three times
Step 3
LED will blink 3 times
Note: To cancel/exit do nothing for 30 seconds
Note: If more than one dimmer is connected to the same load, all dimmers connected
to this load will now blink 3 times
Step 4
Adjust dial to required maximum brightness level
Note: To cancel/exit do nothing for 30 seconds
Step 5
Click once to save & exit
Note: If more than one LEDsmart
brightness levels only needs to be set in one device. The setting is automatically saved
to all other devices connected in parallel
+
device is connected in parallel, the minimum
Setup Functions - Rotary Dimmer/Switch
5
Advertisement
