Configuring Satellite Settings - KVH Industries TracVision R1ST User Manual

TracVision M5/M7 User's Guide
Appendix A - Advanced Settings and Functions

Configuring Satellite Settings

72
Use the flowchart in Figure A-3 to configure one of the satellites
selected for tracking.
TIP: Linear satellites use the following polarization/band combinations:
vertical high, vertical low, horizontal high, and horizontal low. Circular
satellites use the following polarization/band combinations: right and left.
Figure A-3 Configuring Satellite Settings
<Default Display>
Menu
Install Satellite?
Yes Next Return
Select Next until "Operations
Mode?" is displayed.
Operations Mode?
Yes Next Return
Get Antenna Status?
Yes Next Return
Control Antenna?
Yes Next Return
Man Control Antenna?
Yes Next Return
Select Next until "Configure
Satellite?" is displayed.
Configure Satellite?
Yes Next Return
Configure Satellite
Sat A Sat B Sat C
Configure <Sat Name>?
Yes Next Return
Select - or + as required,
then select Enter (valid
polarizations are LHC,
RHC, HH, HL, VH, and VL).
Polarization: ###
- Enter +
Configure frequency?
Yes Next Cancel
Select - or + as required, then
select Enter (valid range is
10700 - 12750 MHz, or 00000).
Set freq: #####MHz
- Enter +
Configure symbol rate?
Yes Next Cancel
Select - or + as required, then
select Enter (valid range is
01000 - 45000 kilosymbols
per second).
Sym Rate: #####M/S
- Enter +
Configure FEC Code?
Yes Next Cancel
Select - or + as required, then
select Enter (valid codes are
1/2, 2/3, 3/4, 5/6, 6/7, 7/8).
Set FEC Code: #/#
- Enter +
Configure Network ID?
Yes Next Cancel
Select - or + as required, then
select Enter (valid range is
0X0000 - 0XFFFF hex).
Set ID: ######HEX
- Enter +