KVH Industries TracVision R1ST User Manual page 54

Step 1 - Configure the Satellites
Use the flowchart in Figure 3-25 to configure the TracVision system for
linear Dual-Sat Mode.
NOTE: Be sure to record the skew angle (the average skew for both satellites)
reported during this procedure. You will need this information to adjust the
TracVision system's skew angle.
Figure 3-25 Configuring Linear Dual-Sat Mode
<Default Display>
Install Satellite? Install Satellite?
Yes Yes
Circular or Linear?
Cir
Trisat Mode?
Yes
Install <SAT NAME>
Yes
Press Next until your choice
for Satellite A is displayed,
then press Yes.
Install <SAT NAME>
Yes
Press Next until your choice
for Satellite B is displayed, then
press Yes. (Choose "NONE" as
your choice for Satellite B if you
wish to install just one satellite.)
IMPORTANT: Choose Auto for
setups without a multiswitch installed;
choose Manual for setups with a
multiswitch installed.
Auto
Menu
Next Return Next Return
Lin Cancel
No Cancel
Next Cancel
Next Cancel
Set Sat Switch Type
Manual Cancel
TracVision M5/M7 User's Guide
Chapter 3 - Settings
Set Lat/Long?
Yes Next Cancel
Latitude: ##N
- Enter +
Press - or + to toggle each
digit to the desired value, then
press Enter to accept each digit.
Longitude: ###E
- Enter +
Press - or + to toggle each
digit to the desired value, then
press Enter to accept each digit.
Latitude: ##N
Longitude: ###E
<SAT A>, and
<SAT B> installed
Restarting Antenna
Record the skew angle for
later use, then press OK.
Skew Angle ##.#
OK
51