Omt Software Installation; Omt Software Version; Non-Volatile Memory; Connection Of The Omt To Equipment - Comba Telecom SR-1910 Installation Manual

4.3.1 OMT SOFTWARE INSTALLATION

Refer to Reference 0.6.3 for installing OMT software. After installing the OMT software on the PC,
connection to the equipment can be done directly or remotely.

4.3.2 OMT SOFTWARE VERSION

OMT software is designed to be backward compatible, to view the OMT software version, select [Help] ->
[About] in the OMT software main window. The [About] window will pop up.

4.3.3 NON-VOLATILE MEMORY

A non-volatile storage device on the MCU holds the configuration of the equipment, the following
information are preserved in the event of power loss:
Repeater Network Configuration
Device ID
SMS report mode including SMS center number and OMC report number setting
Datalink report mode
Operating Parameters
Pre-ATT
Power Supply Switch
Output Power
Gain Reading
Downlink Input Power
Alarm Thresholds
For more information in parameters, refer to ref 0.6.3.

4.4 CONNECTION OF THE OMT TO EQUIPMENT

Before executing the OMT software, physical connection between the OMT software and the equipment
must be made. (See paragraph 3.5.5)
When Slave Unit is included in a centralized control and monitoring system, physical connection between
the Master Unit and Slave Unit must be established. (See paragraph 3.5.6)
After all physical connections of the equipment have been made; user can start the OMT software to
commission the equipment by local or remote connection. Refer to OMT v3.20 product manual.
SR-1910 QI
ENU Status : 1-1-1
INSTALLATION GUIDE FOR SR-1910
Copyright - refer to title page
Page 31