Table of Contents
Advertisement
Connecting the jump leads
WARNING! Never connect the negative
!
terminal of the fully-charged battery to, or in
the vicinity of, the negative terminal of the
discharged battery. Hydrogen gas may be
present with risk of explosion.
•
Connect each end of the red cable to the POSITIVE pole
(+) on each battery, exercise care not to short circuit any
of the ends against the chassis.
Connect one end of the black cable to the NEGATIVE pole
(-) on the fully charged battery.
•
Connect the other end of the black cable to a good
CHASSIS EARTH, away from the fuel tank and the
battery.
Remove the cables in the reverse order
•
The BLACK cable is removed from the chassis and then
the fully charged battery.
•
Finally the RED cable from both batteries.
IMPORTANT INFORMATION Never use a boost charger/
start booster. Use only conventional battery chargers.
Always disconnect the charger before starting the engine.
So called boost chargers/start boosters must never be
used. These will often increase the voltage (instead of the
current) to generate the power needed to start the engine.
This increase in voltage will damage the electrical system.
16 –
English
Driving
Driving the Rider
1 Rider 112C Release the parking brake by first pressing
down the parking brake pedal and then releasing it.
Carefully press down one of the pedals until the required
speed is obtained. Pedal (1) is used to drive forwards, and
pedal (2) to drive backwards.
Rider 112C5 has the brake pedal and lock button on the right
hand side. Release the parking brake by first pressing down
the parking brake pedal and then releasing it.
For Rider 112C5 Disengage the engine and select the
required gear.
- Gears 1-4 are used for mowing
- Gears 4-5 are used for transporting
Gradually release the clutch pedal.
Starting can take place independent of which gear is
engaged.
IMPORTANT INFORMATION
Gear changes between forward gears must not be made
while the machine is moving.
The engine must be disengaged during each gear change.
Stop the machine before changing between forward and
reverse gears, otherwise this may result in damage to the
gearbox.
Never use force to engage a gear. If a gear does not engage
immediately, release the clutch pedal and press it down
again. Now try to engage the gear again.
1
2
Advertisement
Table of Contents
