Starting The Engine With A Weak Battery; Driving The Rider - Husqvarna R 422Ts AWD Operator's Manual

6 When the engine starts release the ignition key
immediately back to neutral position.
CAUTION! Do not run the starter for more than about 5
seconds at a time. If the engine does not start, wait about
15 seconds before trying again.
7 Push the choke lever gradually forward when the engine
has started.
8 Let the engine run at moderate speed or half throttle for 3-
5 minutes before subjecting it to heavy load.
9 Set the required engine speed with the throttle control.
WARNING! Never run the engine indoors, in
!
enclosed or poorly ventilated areas. The
exhaust fumes contain toxic carbon
monoxide.
Starting the engine with a weak
battery
WARNING! Lead-acid batteries produce
!
explosive gases. Avoid sparks, open flames
and smoking close to batteries. Always wear
protective glasses in the vicinity of batteries.
If the battery is too weak to start the engine, it should be
recharged.
When jump leads are used for emergency starting, follow the
procedure below:
IMPORTANT! Your Rider is equipped with a 12-volt system
with negative earth. The other vehicle must also have a 12-
volt system with negative earth. Do not use your Rider
battery to start other vehicles.
16 –
English
Driving
Connecting the jump leads
1
1
WARNING! Never connect the negative
!
terminal of the fully-charged battery to, or in
the vicinity of, the negative terminal of the
discharged battery. Hydrogen gas may be
present with risk of explosion.
1 Connect each end of the red cable to the POSITIVE pole
(+) on each battery, exercise care not to short circuit any
of the ends against the chassis.
2 Connect one end of the black cable to the NEGATIVE pole
(-) on the fully charged battery.
3 Connect the other end of the black cable to a good
CHASSIS EARTH, away from the fuel tank and the
battery.
Remove the cables in the reverse order
• The BLACK cable is removed from the chassis and then
the fully charged battery.
• Finally the RED cable from both batteries.
IMPORTANT! Never use a boost charger/start booster.
Use only conventional battery chargers. Always disconnect
the charger before starting the engine. So called boost
chargers/start boosters must never be used. These will
often increase the voltage (instead of the current) to
generate the power needed to start the engine. This
increase in voltage will damage the electrical system.

Driving the Rider

1 Release the parking brake by first pressing down the
parking brake pedal and then releasing it.
2
3