2 Select the required cutting height (1-5) using the cutting
height lever.
In order to obtain an even cutting height, it is important
that the air pressure is the same in both front wheels. See
the "Technical data" section.
3 Lower the cutting unit.
IMPORTANT INFORMATION
The life span of the drive belts is increased significantly if
the engine runs at a low speed when the blades are
engaged. Therefore apply full throttle first when the cutting
unit has been moved to the mowing position.
Starting on a slope, manual gearbox
(112C5)
1 Press down the parking brake pedal.
2 Push the throttle control to full throttle position.
3 Disengage the engine and select 1st gear.
4 Gradually release the parking brake.
Driving
Stop the engine
Always park the machine on a level surface with the engine
OFF.
Avoid idling the engine for long periods, as there is a risk of
carbon build-up on the spark plugs.
Rider 112C
1 Lift up the cutting unit by pulling the lever backwards to its
locked position.
Pull back the throttle and let the motor idle for at least 30
sec.
2 Turn the ignition key to the "STOP".
3 When the Rider is at a standstill, press down the parking
brake and push in the locking button.
Rider 112C5
1 Lift up the cutting unit by pulling the lever backwards to its
locked position.
2 Pull back the throttle and move the gear shift lever to "N"
– neutral position. Turn the ignition key to the "STOP".
3 When the Rider is at a standstill, press down the parking
brake and push in the locking button.
– 17
English