Driving The Rider; Stop The Engine - Husqvarna R 214T AWD Operator's Manual

Driving the Rider

1 Release the parking brake by first pressing down the
parking brake pedal and then releasing it.
2
1
2 Carefully press down one of the pedals until the required
speed is obtained. Pedal (1) is used to drive forwards, and
pedal (2) to drive backwards.
1
2
3 Select the required cutting height (1-10) with the cutting
height lever.
It is important that the air pressure in both front wheels is
equal, 60 kPa / 0,6 bar / 8.7 PSI, to produce an even
cutting height.
4 Press in the lock button on the lifting lever and lower the
cutting unit.
CAUTION!
The life span of the drive belts is increased significantly if
the engine runs at a low speed when the blades are
engaged. Therefore apply full throttle first when the cutting
unit has been moved to the mowing position.
16 –
English
Driving

Stop the engine

Always park the machine on a level surface with the engine
OFF.
1 Lift up the cutting unit by pulling the lever backwards to its
locked position.
2 Move the throttle to the idle position. Turn the ignition key
to the "STOP".
3 When the Rider is at a standstill, press down the parking
brake and push in the locking button.